Brick & Concrete Walls


Even Walls Procedures:

  • For clean and sound wall use flexible tile adhesive. Coat the wall surface or apply adhesive directly to the board surface (min. thickness 10mm).
  • Comb out with 10mm trowel creating a ribbed adhesive bed. Offer up boards and align vertically and horizontally bed firmly into place.
  • If adhesion can not be achieved by adhesive use dowels, screws and washers at the rate of 15 per sheet. Use min. 20mm boards.
  • Cover all joints with fibreglass tape embedded in flexible tile adhesive.

Uneven Walls Procedures:

  • Drill the board at the rate of 15 dowels per board (min. 20mm thick)
  • Place dabs of adhesive to be placed on the holes, then the board to be offered up and aligned vertically and horizontally.
  • Once the adhesive dries, drill the board through the holes and the wall, and insert dowels, washers and screws, hammer the washer with rubber malt to finish level with board surface.
  • Tape all the joints and apply flexible tile adhesive in the usual manner, and when the adhesive dries, the wall can be tiled.

marmox board advantages

  • Waterproof
  • Heat insulation
  • Sound insulation
  • Extremely strong
  • Load bearing
  • Lightweight
  • Easy to work with
  • Cost effective
  • Environmentally friendly

Marmox Guides

© Marmox Australia 2013. Site by oneos